If you have a furnace that is having trouble, you may need to contact a professional service provider to fix the problem. There are a few things you should check before contacting a service provider. Firstly, check that the Air intake pipe is not clogged with leaves or other debris. If it is, then you should consider changing the Air filter. Secondly, check the bearings and replace any worn ones.
Air intake pipe is blocked
If your furnace has trouble starting or blowing hot air, it could be because the air intake pipe is blocked. A professional HVAC technician will open up the furnace and remove any debris clogging the pipe. The intake pipe is usually located near the foundation. It is usually black and curved. The Furnace Repair exhaust pipe will be straight up. It is a good idea to check it before a cold snap arrives.
Air intake pipe is not blocked by leaves or other debris
To make sure that your A/C or furnace works efficiently, it is important to make sure that the air intake pipe is not blocked by leaves or other items. These items can prevent fresh air from entering the system, causing it to malfunction. In addition to leaves, debris and shrubs can block air intake, too. To prevent this from happening, keep a 3-foot area around the intake and exhaust pipes clear of any debris.
Air filter needs to be changed
One of the first steps to take during a furnace repair is replacing the air filter. These filters are usually located on the front side of the furnace near the blower system. Some are easily accessible, and others may require the removal of a metal panel. You may need to remove the panel and slide the air filter out of a slot. Afterwards, inspect the filter to ensure that it is clean and functioning properly.
Replace worn out bearings
Replace worn out bearings in your furnace to keep the furnace running smoothly. They are a simple mechanical component but are a vital part of your HVAC system. Bearings reduce friction and noise pollution, but over time they can begin to wear down and eventually stop working altogether. To avoid this problem, it is important to have these parts replaced by a professional HVAC specialist.
Check for leaky ducts
A simple way to spot a leak is to look for wet spots and mold in the air ducts. These are located in the attic or basement of your home. To perform this check, gather some basic tools such as a flashlight and rags. If you find any, you can call in a professional technician. You should be careful when performing this task because it can cause health risks.
Check for a blown fuse or circuit breaker
To check if your furnace has a blown fuse, turn off the electricity to the furnace. You can do this at the main electrical panel or the subpanel for your furnace. You should see a plastic or glass box with a metal bar on one side and a wire attached to it on the other.