If you aren’t comfortable tackling the task yourself, consider hiring a professional for your Furnace Repair. A higher-quality technician will charge more money up front, but you’ll save money in the long run. Here are some tips for hiring a reputable technician. You may be able to fix some problems yourself, too, by reading this article. Listed below are some important components of your Furnace Repair.
Electric ignitor
In the event of a broken furnace ignitor, you may need to replace the entire ignitor or just a part of it. You can buy an electric ignitor kit that includes the entire assembly, including longer wiring and mounting brackets. In most cases, reaching the igniter is not a difficult task, even if it is not easy to remove the panel of the furnace. Disassembling the furnace may be necessary for some brands of furnaces, which increases the labor costs. Moreover, the troublesome models of furnaces are more expensive than those that are easy to access.
Power switch
When you suspect that your furnace may be in need of furnace repair, the first Furnace Repair thing you need to do is check the power switch. Many people mistake this switch for a light switch. This could be dangerous, since you might accidentally switch the power off. Oftentimes, the switch is in the “safety off” position and not working properly. If you find that the switch has been tripped, you must contact a professional.
Circuit breaker
A faulty motor is another common cause of a tripped circuit breaker in a furnace. This can lead to short circuits and other problems, so you should only attempt to replace this part with an authentic HVAC technician. Additionally, a faulty motor can cause the circuit breaker to trip when the airflow is restricted, reducing the efficiency of the system. You should also contact a professional if you have any doubts about the motor’s performance or if it has been replaced.
Oil nozzle
If your furnace is having trouble heating your home, it may be time to replace the oil nozzle. While this process may seem complicated, changing this component is easy and doesn’t take much time. Depending on the make and model of your furnace, it might even be a DIY job. Here are some tips to remember while replacing your oil nozzle. To begin with, you should avoid contaminating the bronze filter or touching the nozzle’s small hole. Dirt and debris from these areas will have an adverse impact on the nozzle’s performance.
Water leak
If you are experiencing water dripping from your furnace, you should immediately shut off the furnace and shut off the breaker box. Then, mop up any water that is around the unit. The water can damage the furnace and the floor, so it is important to turn off the furnace before mopping. Once you have turned off the breaker box, turn off the power to the furnace, and turn off the shut-off valve on the gas line. If there is any water left behind, mop up the water with a wet-dry vacuum.
Rapid cycling
Usually a malfunction in your furnace is to blame for rapid cycling. There are several reasons why your furnace is short cycling. Some of them you can fix yourself, and some require a professional HVAC technician to identify and repair. Overheating is usually caused by restricted airflow. It can be caused by a dirty air filter or by blocking interior vents. The pilot light in older models can also be malfunctioning. If you notice your furnace is short cycling more often than it should, you may have an issue with your thermostat.